Schneider Electric ALTIVAR 58 TRX Guida di Installazione Scaricare il pdf (Pagina 10)

Chapter 1—Overview VVDED397047USR6/03

Firmware Revision Information 06/2003

3Q 2000 V3.1 IE 16 V3.0 IE 08

Began production of 5–25 hp, 460 Vac variable torque rated

drive controllers without the integrated EMC filter for 460 Vac

installations where the filter is not required. Removing this filter

allowed the product to be rated for additional horsepower at

460 Vac. These drive controllers have the ability to be

configured for VT plus as described on page 27.

3Q 2001 V4.1 IE 25 V4.1 IE 13

Relay R2 is no longer factory set for an output contactor. The

factory setting is “not assigned.”

The following functions were added:

• Run time meter function, rth, and watt-hour meter function,

APH. Both meters can be reset with rpr.

• Two additional jump frequencies are JF2 and JF3.

• A second programmable frequency threshold with logic

output configuration, F2d, F2A.

• The ability to provide torque limit via analog input AI3,

activated by a logic input, TLA and ATL.

• Minimum adjustment of nominal motor frequency, FrS,

changed from 40 Hz to 10 Hz.

• Ability to configure a freewheel stop below a programmable

frequency with Stt and FFT.

• PI regulator has been enhanced to accept programmable

setpoints through the keypad display with the use of logic

inputs PR2 and PR4.

• PI regulator has been enhanced with time-constant filter on

feedback, PSP.

• Parameter, tbr, for a baud rate selection on an integrated

MODBUS port.

• Operation of an extremely undersized motor and the ability

to configure an output voltage test mode by configuring

PSM.

• Ability to configure loss of follower fault to run at pre-set

speed, LFF, and signal loss of follower with logic output,

APL.

Additional assignments possible to an analog output on an

option card:

Compatible with Ethernet, MODBUS

, TCP/IP communication

card, and Forced local function.

4Q 2001 V4.2 IE 28 V4.1 IE 13

PI regulator has been enhanced to work with Auto/Manual

(reference switching) PAU, PIF, PIM.

Table 2: Product Upgrade and Revision Level History (continued)

Date

Drive

Controller

Firmware

Revision

Associated

Keypad

Display

Firmware

Revision

Description of Major Function Upgrade

• Signed ramp output, ORS • Motor power, OPR

• PI setpoint, OPS • PI feedback, OPF

• PI error, OPE • PI integral, OPI

• Motor thermal state, THR • Drive thermal state, THD

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 125 126

Commenti su questo manuale

Nessun commento

Schneider Electric ALTIVAR 58 TRX Guida di Installazione Pagina 10

Commenti su questo manuale

Prodotti e manuali riguardandi Misurazione, test & controllo Schneider Electric ALTIVAR 58 TRX