Schneider Electric TSXETG100 Manuale Utente Scaricare il pdf (Pagina 44)

Services

TSX ETG 1000 as BOOTP Client

Principle The principle used is as follows:

l The TSX ETG 1000 module requests an IP configuration (IP address, subnet

mask, gateway) from a BOOTP server by means of its MAC address.

l The BOOTP server uses a MACAddress/IP Configuration correspondence table

to return the IP configuration to the TSX ETG 1000.

Initial Startup Behavior of the TSX ETG 1000 module on initial startup:

The TSX ETG 1000 module sends a configuration request to the server:

l If the module is not recognized, it starts up with its default IP configuration

(factory-set)

l If the BOOTP server sends an IP configuration, the TSX ETG 1000 uses it but

without storing it in Flash memory.

Subsequent

Startups

Behavior of the module on subsequent startups:

The TSX ETG 1000 module sends a configuration request to the server:

l If the BOOTP server sends a configuration, the TSX ETG 1000 uses it.

l If the BOOTP server does not respond within about 5 minutes, the

TSX ETG 1000 module switches to downgraded operating mode and uses the IP

configuration stored in the Flash memory (the factory-set default configuration).

Note: Important: In order to use the BOOTP service, you must configure the

address server as BOOTP server and identify the client device by its MAC address.

Note: The BOOTP server only returns the IP address, the subnet mask and the

gateway; the other data can be found in the configuration page.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 191 192

Nessun commento

Schneider Electric TSXETG100 Manuale Utente Pagina 44